Opening/closing the garage door
Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.
– Turn the SmartKey to position 2 in the
ignition lock.
– Press transmitter button 2, 3 or 4 in the
overhead control panel that you have
programmed to operate the garage door.
Garage door system with a fixed code:
indicator lamp 1 lights up green.
Garage door system with a rolling code:
indicator lamp 1 flashes green.
The transmitter will transmit a signal for as long as the transmitter button is being pressed. After a maximum of ten seconds, transmission is terminated and indicator lamp 1 flashes yellow. Press the transmitter button again, if necessary.
See also:
Vehicle identification plate
Even if you have calculated the total load
carefully, you should still make sure that the
gross vehicle weight rating and the gross axle
weight rating are not exceeded. Details can
be found on ...
Ashtray in the rear-compartment center
console
The ashtrays are located in the rear doors.
To open: lift up cover 2.
To remove the insert: press open
cover 2 past the stop.
Insert 1 pops out of the holder.
Lift insert 1 up and out.
To ...
Hiding display messages
You can hide some display messages with a low priority.
You can hide some display messages with a low priority.
– Press the or
button on the steering wheel to
hide the display message.
The dis ...