Telescopic rod

The telescopic rod can be used to secure the load against the rear seats to prevent it from moving around.

– To install: insert one bracket 2 into both

– To install: insert one bracket 2 into both the left and the right loading rails and slide it to the desired position.
– Insert telescopic rod 1 into brackets 2 and, while doing so, press release button 4 and push the rod downwards until it engages.
– Make sure that locking button 3 on brackets 2 is pressed.
This keeps brackets 2 in place on the loading rail.
– To remove: press release button 4 on respective bracket 2 and remove telescopic rod 1 by pulling it upwards and out.

    See also:

    Important safety notes
    WARNING When leaving the vehicle, always remove the SmartKey from the ignition lock. Always take the SmartKey with you and lock the vehicle. Do not leave children unsupervised in the vehicle ...

    SmartKey
    0 To remove the SmartKey (shift the transmission to position P) 1 Power supply for some consumers, such as the windshield wipers 2 Ignition (power supply for all consumers) and drive position 3 T ...

    Adjusting the four-way lumbar support
    You can adjust the contour of the front seat backrests individually to provide optimum support for your back. 1 To raise the backrest contour 2 To soften the backrest contour 3 To lower the ...