Front air bags

The front air bags increase protection for the driver's and front-passenger's head and chest.

Driver's air bag 1 deploys in front of the

Driver's air bag 1 deploys in front of the steering wheel; front-passenger front air bag 2 deploys in front of and above the glove box.

They are deployed:
- in the event of certain frontal impacts
- if the system determines that air bag deployment can offer additional protection to that provided by the seat belt
- if the seat belt is fastened
- independently of other air bags in the vehicle

If the vehicle overturns, the front air bags are generally not deployed unless the system detects high vehicle deceleration in a longitudinal direction.

Your vehicle has adaptive, two-stage front air bags. In the event of a collision, the air bag control unit evaluates the vehicle deceleration. In the first deployment stage, the front air bag is filled with enough propellant gas to reduce the risk of injuries.

The front air bag is fully deployed if a second deployment threshold is exceeded within a few milliseconds.

The deployment of the front-passenger front air bag is also influenced by the weight category of the front passenger, which is determined by the Occupant Classification System (OCS).

The lighter the passenger side occupant, the higher the vehicle deceleration rate required (predicted at the start of the impact) for second stage inflation of the front-passenger front air bag. In the second stage, the front air bags are inflated with the maximum amount of propellant gas available.

The front air bags are not deployed in situations where a low impact severity is predicted. You will then be protected by the fastened seat belt.

The front-passenger front air bag will only deploy if:
- the system, based on the OCS weight sensor readings, detects that the frontpassenger seat is occupied.
- the console is not lit. indicator lamp in the center console is not lit.
- the air bag control unit predicts a high impact severity.

    See also:

    Cleaning the trailer tow hitch
    The ball coupling must be cleaned if it becomes dirty or corroded. Remove rust on the ball of the ball coupling, e.g. with a wire brush. Remove dirt with a clean, lint-free cloth or a brush. A ...

    "Minispare" emergency spare wheel/ collapsible spare wheel
    Opening the stowage well Sedan: the emergency spare wheel can be found in the stowage well under the trunk floor. •► Lift the trunk floor upwards Example: well insert •► Release ...

    High-beam headlamps
    •► To switch on the high-beam headlamps: turn the SmartKey in the ignition lock to position 2 or start the engine. •► Turn the light switch to or . •► Press the combination ...