Tire tread

WARNING Although the applicable federal motor vehicle 
Although the applicable federal motor vehicle safety laws consider a tire to be worn when the tread wear indicators (TWI) become visible at approximately 1/16 in (1.6 mm), we recommend that you do not allow your tires to wear down to that level. As tread depth approaches 1/8 in (3 mm), the adhesion properties on a wet road are sharply reduced.
Depending upon the weather and/or road surface (conditions), the tire traction varies widely.

Do not use tires that are excessively worn as the tire traction on wet road surfaces decreases significantly when the tread depth is less than 1/8 inch (3 mm).

Tread wear indicators (TWI) are required by law. Six indicators are positioned over the tire tread. They are visible as soon as a tread depth of approx. 1/16 inch (1.6 mm) is reached. If this is the case, the tire is so worn that it must be replaced.

The recommended tread depth for summer tires is at least 1/8 inch (3 mm). The recommended tread depth for winter tires is at least 1/6 inch (4 mm).

Bar marking 1 for tread wear is integrated

Bar marking 1 for tread wear is integrated into the tire tread.

    See also:

    DOT, Tire Identification Number (TIN)
    U.S. tire regulations prescribe that every manufacturer of new tires or retreader has to imprint a TIN in or on the sidewall of each tire produced. The TIN is a unique identification number. The ...

    Safety & Features
    As of this writing, neither the National Highway Traffic Safety Administration nor the Insurance Institute for Highway Safety has tested the E-Class wagon. (IIHS has tested the E-Class sedan, but ...

    Data stored in the vehicle
    Information about electronic data acquisition in the vehicle (Including notice pursuant to California Code § 9951) Your vehicle records electronic data. If your vehicle is equipped with mbrace ...