Using the TIREFIT kit
You can use the TIREFIT kit to seal small punctures, particularly those in the tire tread.
You can use TIREFIT at outside temperatures down to -4 °F (-20 °C).
WARNING
TIREFIT is a limited repair device. TIREFIT
cannot be used for cuts or punctures larger
than approximately 0.16 in (4 mm) and tire
damage caused by driving with extremely low
tire inflation pressure, or on a flat tire, or a
damaged wheel.
Do not drive the vehicle under such
circumstances.
Contact the nearest authorized Mercedes-Benz Center for assistance or call
Roadside
Assistance.
► Do not remove any foreign objects which
have penetrated the tire, e.g. screws or
nails.
► Remove the tire sealant bottle, the
accompanying "max. 80 km/h" sticker and
the tire inflation compressor from the
stowage well underneath the trunk floor.
► Affix part 1 of the sticker within the
driver's field of vision.
► Affix part 2 of the sticker near the valve
on the wheel with the defective tire.
WARNING
Take care not to allow the contents of TIREFIT
to come in contact with hair, eyes or clothing.
TIREFIT is harmful if inhaled, swallowed or
absorbed through the skin - causes skin, eye
and respiratory irritation.
Any contact with eyes or skin should be
flushed immediately with plenty of water.
If clothing comes in contact with TIREFIT,
change clothing as soon as possible.
In case of allergic reaction or rash, consult a
physician immediately.
WARNING
Keep TIREFIT away from children. If
swallowed, rinse mouth immediately with
plenty of water and drink plenty of water.
Do not induce vomiting.
Consult a doctor immediately.
Keep away from open flame or heat source.
If TIREFIT leaks out, allow it to dry. It can then be removed like a layer of film.
If you get TIREFIT on your clothing, have it cleaned as soon as possible with perchloroethylene.
Your vehicle is provided with one of two different tire inflation compressors:
• Version 1: the hose with the pressure
gauge and the cable are behind a flap.
• Version 2: the pressure gauge is in the
tire
inflation compressor.
See also:
Correct driver's seat position
Observe the safety guidelines on seat
adjustment.
- Check whether you have adjusted seat 3
properly.
Electrical seat adjustment
When adjusting the seat, make sure:
- you ...
Checking the coolant level
Only check the coolant level when the vehicle
is on a level surface and the engine has cooled
down.
► Turn the SmartKey to position
2 in the ignition lock.
On vehicles with KEYLESS-GO, ...
Checking tire pressures manually
To determine and set the correct tire
pressure, proceed as follows:
– Remove the valve cap of the tire that is to
be checked.
– Press the tire pressure gauge securely onto
the valve.
– Read t ...