Opening/closing the garage door
Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.
► Turn the SmartKey to position 2 in the
ignition lock.
► Press transmitter button 2, 3 or 4 in the
overhead control panel that you have
programmed to operate the garage door.
Garage door system with a fixed code:
indicator lamp 1 lights up green.
Garage door system with a rolling code:
indicator lamp 1 flashes green.
The transmitter will transmit a signal for as long as the transmitter button is being pressed. After a maximum of ten seconds, transmission is terminated and indicator lamp 1 flashes yellow. Press the transmitter button again, if necessary.
See also:
Points to observe before use
The sockets can be used for accessories, e.g.
lamps or mobile phone chargers with a
maximum current draw of 180 W (15 A).
If you use the sockets for long periods when
the engine is switched off, ...
Important safety notes
The coolant is a mixture of water and
antifreeze/corrosion inhibitor. It performs
the following tasks:
- corrosion protection
- antifreeze protection
- raising the boiling point
The engine coo ...
Restarting the tire pressure monitor
WARNING
It is the driver's responsibility to set the tire
pressure to the recommended cold tire
pressure. Underinflated tires affect the ability
to steer or brake the vehicle. You migh ...