Tail lamps with LEDs
1 Rear fog lamp
2 Backup lamp
► Switch off the lights.
► Open the cargo compartment.
► Open the side trim panel.
► Turn the corresponding bulb holder
counter-clockwise and remove it.
► Remove the bulb from the bulb holder.
► Insert the new bulb into the bulb
holder.
► Insert the bulb holder and turn it
clockwise.
► Close the side trim panel.
See also:
Importing contacts automatically
If a mobile phone is connected to COMAND
via the Bluetooth® interface, the contacts
(phone book entries) of the mobile phone are
automatically imported into COMAND's
phone book.
Depending on ...
Resetting to factory settings
For safety reasons, the Daytime Running
Lamps function in the Lighting submenu is
only reset when the engine is switched off.
► Press
on the steering wheel
to select the Settings menu.
...
Storing a destination in the destination
memory
Note
This function also stores the destination in
the address book.
After destination entry
The destination has been entered and is
shown in the address entry menu.
Select Save by sliding a ...