Opening and closing the sidewindows

1 Front left

1 Front left
2 Front right
3 Rear right
4 Rear left

The switches for all side windows are located on the driver's door. There is also a switch on each door for the corresponding side window.

The switches on the driver's door take precedence.

from the rear when the override feature for The side windows cannot be operated from the rear when the override feature for the side windows is activated.

► Turn the SmartKey to position 1 or 2 in the ignition lock.
► To open: press the corresponding switch.
► To close: pull the corresponding switch.

of resistance, an automatic opening/closing process is started in the If you press the switch beyond the point of resistance, an automatic opening/closing process is started in the corresponding direction. You can stop automatic operation by operating the switch again.

windows after you switch off the engine or You can continue to operate the side windows after you switch off the engine or remove the SmartKey. This function is available for up to five minutes or until the driver's or front-passenger door is opened.

    See also:

    Activating/deactivating Blind Spot Assist
    You can use the Blind Spot Asst. function to activate or deactivate Blind Spot Assist (Y page 198) or Active Blind Spot Assist. – Press or on the steering wheel to select the DriveAssist men ...

    introduction
    You can establish a Bluetooth® connection to COMAND (see the separate operating instructions). WARNING A driver's attention to the road must always be his/her primary focus when driving. F ...

    Information about driving abroad
    Converting to symmetrical low beam when driving abroad: switch the headlamps to symmetrical low beam in countries in which traffic drives on the opposite side of the road to the country where ...