Checking tire pressure electronically
- Make sure that the SmartKey is in position 2 () in the ignition lock.
- Press the
or
button on the steering wheel to select the Service menu.
- Press the
or
button to select Tire Pressure.
- Press the
button. The current tire pressure for each wheel will be displayed in the multifunction display.
If the vehicle has been parked for longer than 20 minutes, the Tire pressures will be displayed after driving a few minutes message appears in the display.
After a teach-in period, the tire pressure monitor automatically recognizes new wheels or new sensors. If a clear allocation of the tire pressure values to the individual wheels is not possible, the Tire Pressure Monitor Active message is shown instead of the tire pressure display. The tire pressures are already being monitored.
If a spare wheel/emergency spare wheel is mounted, the system may continue
to show the tire pressure of the wheel that has been removed for a few minutes.
If this occurs, note that the value displayed for the position where the spare tire
is mounted is not the same as the spare wheel/emergency spare wheel's current tire
pressure.
See also:
Vehicle identification plate
Even if you have calculated the total load
carefully, you should still make sure that the
gross vehicle weight rating and the gross axle
weight rating are not exceeded. Details can
be found on ...
Belt warning for the driver and front
passenger
Regardless of whether the driver and front
passenger have fastened their seat belts
already, the seat belt warning lamp
lights up for 6 seconds after every engine
start. It then goes out if t ...
Important safety notes
WARNING
The following factors increase the risk of
accidents:
• Excessive speed, especially in
turns
• Wet and slippery road surfaces
• Following another vehicle too
closely
The ...