Preparing the vehicle
- Stop the vehicle as far away as possible from traffic on solid, non-slippery and level ground.
- Switch on the hazard warning lamps.
- Firmly depress the parking brake.
- Bring the front wheels into the straightahead position.
- Move the selector lever to P.
- Switch off the engine.
- Vehicles without KEYLESS-GO: remove the SmartKey from the ignition lock.
- Vehicles with KEYLESS-GO: open the driver's door. The on-board electronics have status 0, which is the same as the SmartKey having been removed.
- Vehicles with KEYLESS-GO: remove the Start/Stop button from the ignition lock ().
- All occupants must get out of the vehicle. Make sure that they are not endangered as they do so.
- Make sure that no one is near the danger area while a wheel is being changed. Anyone who is not directly assisting in the wheel change should, for example, stand behind the barrier.
- Get out of the vehicle. Pay attention to traffic conditions when doing so.
- Close the driver's door.
See also:
Resetting to factory settings
For safety reasons, the Daytime Running
Lamps function in the Lighting submenu is
only reset when the engine is switched off.
► Press
on the steering wheel
to select the Settings menu.
...
Activation conditions
You can activate the HOLD function if:
• the vehicle is stationary.
• the driver's door is closed or your seat belt is fastened.
• the electric parking brake is released.
• the hood is clo ...
Notes on care
Regular care of your vehicle is a condition for
retaining the quality in the long term.
Use care products and cleaning agents
recommended and approved by Mercedes-
Benz.
WARNING
Many cleani ...