Calibrating the compass
- Make sure that there is sufficient space for you to drive in a circle without impeding the remaining traffic.
In order to calibrate the compass correctly, observe the following points:
- calibrate the compass in the open and not in the vicinity of steel constructions or highvoltage transmission lines.
- switch off electrical consumers, for example, the climate control, windshield wipers or rear window defroster.
- close all doors and the tailgate.
- Switch the ignition on.
- Press a round pin into opening 3() for approximately six seconds until the C symbol appears in compass display 2().
- Drive a full circle at approximately 3 mph (5 km/h) to 6 mph (10 km/h). Once the calibration has been successfully completed, the current direction appears in compass display 2().
See also:
Active Lane Keeping Assist
Important safety notes
Active Lane Keeping Assist monitors the area
in front of your vehicle by means of a camera
at the top of the windshield. Active Lane
Keeping Assist detects lane markings ...
The model range: Every CLS is a one-off
Individuality is written large in the new Mercedes CLS. The model range for
the four-door Coupé is correspondingly extensive - it will be at first be
available with rear-wheel drive and the ...
Driving tips
Observe the information on ESP® trailer
stabilization (Y page 64) and on pulling
away with a trailer.
The maximum permissible speed for vehicle/
trailer combinations depends on the type of ...