Opening/closing the garage door
Once programmed, the integrated remote control will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.
X Turn the SmartKey to position 2 in the ignition lock.
X Press transmitter button 2, 3 or 4 in the overhead control panel that you have programmed to operate the garage door. Garage door system with fixed code: indicator lamp 1 lights up continuously.
Garage door system with rolling code: indicator lamp 1 flashes briefly and then lights up for approximately two seconds. This is repeated for up to 20 seconds.
The transmitter will transmit a signal for as long as the transmitter button
is being pressed. The transmission will be halted after a maximum of 20 seconds
and indicator lamp 1 will flash. Press the transmitter button again, if necessary.
See also:
Setting a speed
WARNING
Keep in mind that it may take a brief moment until the vehicle has made the necessary
adjustments.
Increase or decrease the set vehicle speed to a value that the prevailing road
con ...
Genuine Mercedes-Benz parts
All Mercedes-Benz Centers maintain a supply
of genuine Mercedes-Benz parts for
necessary service and repair work. In
addition, strategically located parts delivery
centers provide for quick an ...
Extending and retracting the cargo
compartment cover
– To extend: pull the cargo compartment
cover back by grab handle 1 and clip it
into retainers 2 on the left and right.
– To retract: unhook the cargo compartment
cover from retainers 2 on ...