Turn signal lamps/side marker lamps
- Switch off the lights.
- Open the hood.
- Remove the headlamp cover ().
- Left-hand headlamp: detach the washer fluid reservoir ().
- Turn bulb holder 1 or 2 counterclockwise and pull it out.
- WY 5 W (turn signal lamp and side marker lamp): remove the bulb from bulb holder 1.
- PY 21 W (turn signal lamp): turn the bulb counter-clockwise, applying slight pressure, and remove it from bulb holder 2.
- WY 5 W (turn signal lamp and side marker lamp): insert the new bulb into bulb holder 1.
- PY 21 W (turn signal lamp): insert the new bulb into bulb holder 2 and turn it clockwise while applying slight pressure.
- Insert bulb holder 1 or 2 and turn it clockwise.
- Left-hand headlamp: fasten the washer fluid reservoir ().
- Install the headlamp cover ().
See also:
Maximum gradient-climbing capability
For good road surface conditions, the
maximum gradient-climbing capability is
100%, which corresponds to an approach/
departure angle of 45°. Note that the
vehicle's gradient-climbing capability
...
Changing gear
The automatic transmission shifts to the
individual gears automatically when it is in
transmission position D. This automatic
gearshifting behavior is determined by:
• a shift range restricti ...
Matte finish care
If your vehicle has a clear matte finish, observe the following instructions
in order to avoid damage to the paintwork due to incorrect care.
These notes also apply to light alloy wheels with a cle ...