Removing/installing the headlamp cover

You must remove the headlamp cover in the engine compartment before you can replace the bulbs in the headlamp.

  1. To remove: press retaining clip 1 in the direction of the arrow.
  2. Pull cover 2 forward underneath cover 3 and remove.
  3. To install: slide cover 2 under cover 3. Connect the two covers by inserting the tongue into the groove.
  4. Press cover 2 until retaining clip 1 engages.
    See also:

    Tires
    Display messages USA only: The yellow tire pressure monitor warning lamp (pressure loss/ malfunction) is lit. Possible causes/consequences and ► Solutions Risk of accident The tire ...

    Setting the footwell temperature
    The footwell temperature can be set via COMAND. ...

    Dialing a number from the phone book
    You can enter new telephone numbers into the phone book via the mobile phone (see the separate operating instructions). If your mobile phone is operational, you can select and dial a number from t ...