Top Tether
WARNING
Always lock the rear seat backrests in their upright position when the rear seats are occupied by passengers. Lock the rear seat backrests in their upright position before installing the Top Tether straps or when the cargo compartment is not in use. Make sure that rear seat backrests are secured properly by pushing and pulling on the seat backrests. If the seat backrest is not locked properly, the seat backrest could fold forward. The child restraint system is no longer supported properly or held in position and can no longer fulfill its function. This could cause serious or even fatal injuries.
Top Tether provides an additional connection between the child restraint system secured with ISOFIX and the rear seat. It helps reduce the risk of injury even further.
The Top Tether anchorages are located on the rear side of the rear seat backrests.
- Move head restraint 2 upwards.
- Install the LATCH-type (ISOFIX) child restraint system with Top Tether. Comply with the manufacturer's installation instructions when doing so.
- Route Top Tether belt 5 under head restraint 1 between the two head restraint bars.
- Route Top Tether belt 5 downward between cargo compartment cover 2 and the rear seat backrest.
- Hook Top Tether hook 4 of Top Tether belt 5 into Top Tether anchorage
3.
Ensure that:- Top Tether hook 4 is hooked into Top Tether anchorage 3 as shown.
- Top Tether belt 5 is not twisted.
- Top Tether belt 5 is routed between the rear seat backrest and cargo compartment cover 2 if cargo compartment cover 2 is installed.
- Top Tether belt 5 is routed between the rear seat backrest and the cargo net if the cargo net is installed.
- Tension Top Tether belt 5. Comply with the manufacturer's installation instructions when doing so.
- Move head restraint 1 back down again slightly if necessary (). Make sure that you do not interfere with the correct routing of Top Tether belt 5.
See also:
BAS (Brake Assist System)
Observe the "Important safety
notes"
section.
BAS operates in emergency braking
situations. If you depress the brake pedal
quickly, BAS automatically boosts the braking
force, th ...
Restoring the factory settings
Press the
and
buttons simultaneously for
approximately six seconds until the battery check lamp flashes twice. ...
Please bear the following in mind
Resetting service interval display
If the qualified specialist workshop, e.g. a
Mercedes-Benz Center, carried out the
maintenance work, the service interval
display will be reset.
Further info ...