Checking tire pressure manually

To determine and set the correct tire pressure, proceed as follows:

be checked. Remove the valve cap of the tire that is to be checked.

the valve. Press the tire pressure gauge securely onto the valve.

the recommended value on the Tire and Read the tire pressure and compare it with the recommended value on the Tire and Loading Information placard on the B-pillar on the driver's side of your vehicle.

the recommended value. If necessary, increase the tire pressure to the recommended value.

by pressing down the metal pin in the valve If the tire pressure is too high, release air by pressing down the metal pin in the valve using the tip of a pen, for example. Then check the tire pressure again using the tire pressure gauge.

Repeat these steps for the other tires. Screw the valve cap onto the valve.

Tire pressure monitor Repeat these steps for the other tires.

    See also:

    Matte finish care
    If your vehicle has a clear matte finish, observe the following instructions in order to avoid damage to the paintwork due to incorrect care. These notes also apply to light alloy wheels with a cle ...

    Pedestrian recognition
    WARNING Pedestrian recognition may be impaired or inoperative if: - pedestrians are partially or entirely obscured by objects, e.g. parked vehicles. - the silhouette of the pedestrian in the N ...

    Roller sunblind, rear panorama roof
    The rear panorama roof roller sunblind protects the vehicle occupants in the third row of seats from direct sunlight. You can open/close the roller sunblind by hand. Always guide the roller ...