Important notes on tire pressure
WARNING
Should the tire pressure drop repeatedly:
• check the tire for foreign bodies.
• check whether the wheel is losing air or the
valve is leaking.
• make sure that only a valve cap approved
by Mercedes-Benz is used on the tire valve.
Tire pressures that are too low have a
negative effect on vehicle safety, which could
lead you to cause an accident.
To test tire pressure, use a suitable tire pressure gauge. The outer appearance of a tire does not permit any reliable conclusion about the tire pressure. On vehicles equipped with the electronic tire pressure monitoring system, the tire pressure can be checked using the on-board computer.
The tire temperature and pressure increase when the vehicle is in motion. This is dependent on the driving speed and the load.
Therefore, you should only correct tire pressures when the tires are cold.
The tires are cold:
• if the vehicle has been parked without
direct sunlight on the tires for at least three
hours and
• if the vehicle has not been driven more than
1 mile (1.6 km).
The tire temperature changes depending on the outside temperature, the vehicle speed and the tire load. If the tire temperature changes by 18 °F (10 °C ), the tire pressure changes by approximately 10 kPa (0.1 bar/1.5 psi). Take this into account when checking the pressure of warm tires and only correct the tire pressure if it is too low for the current operating conditions. If you check the tire pressure when the tires are warm, the resulting value will be higher than if the tires were cold. This is normal. Do not reduce the tire pressure to the value specified for cold tires. The tire pressure would otherwise be too low.
Observe the recommended tire pressures for
cold tires
• on the Tire and Loading Information placard
on the B-pillar on the driver's side,
• in the tire pressure table on the inside of
the fuel filler flap,
• printed in yellow on the rim of the
emergency/collapsible spare wheel
(depending on vehicle equipment).
See also:
License plate lamps
Switch off the lights.
Open the tailgate.
Press lug 2 of license plate lamp 1 in the direction of the arrow and
remove license plate lamp lens 1.
Remove license plate lamp lens 1.
Repl ...
Activating/deactivating the acoustic
locking verification signal
If you activate the Acoustic Lock Feedb.
function, an audible signal sounds depending
on the vehicle's date of manufacture:
• when locking
or
• once when unlocking and three times when loc ...
Important safety notes
The EASY-ENTRY/EXIT feature makes getting in and out of your vehicle easier.
You can activate and deactivate the EASYENTRY/ EXIT feature in the on-board computer
().
WARNING
You must make su ...