Switching on Night View Assist Plus

You can only activate Night View Assist Plus if:

You can only activate Night View Assist Plus if:
• the SmartKey is in position 2 in the ignition lock.
• it is dark.
• the light switch is in the position. or position.
• reverse gear has not been engaged.

The Night View Assist Plus display appears Press button 1.

The Night View Assist Plus display appears in the multifunction display.

1 Night View Assist Plus display

1 Night View Assist Plus display
2 Pedestrian recognized
3 Framing
4 Symbol for active pedestrian recognition
5 Speed display

automatically from a speed of about 6 mph The infrared lamps switch on automatically from a speed of about 6 mph (10 km/h). This means that you do not have the full visual range while the vehicle is stationary and cannot check whether Night View Assist Plus is working.

When you activate Night View Assist Plus, speed display 5 in the multifunction display changes. Speed display 5 is shown as a bar at the bottom edge of the multifunction display. This line is no longer available for basic menus. You have to deactivate Night View Assist Plus if you want to change a setting using the buttons on the multifunction steering wheel.

    See also:

    LATCH-type (ISOFIX) child seat anchors in the rear
    WARNING Children that are too large for a child restraint must travel in seats using normal seat belts. Position shoulder belt across the chest and shoulder, not face or neck. In order to a ...

    Decoupling a trailer
    WARNING   While you are coupling or decoupling a trailer, make sure nobody locks or unlocks the vehicle and/or opens or closes doors or the tailgate. The vehicle's level could change an ...

    Cleaning the seat belts
    Use clean, lukewarm water and soap solution. Do not clean the seat belts using chemical cleaning agents. Do not dry the seat belts by warming them above 176 °F (80 °C) or placing them in di ...