Warning and display messages in the multifunction display
Activate ATTENTION ASSIST using the onboard computer.
Symbol 1 appears in the multifunction display.
If ATTENTION ASSIST is active, you will be warned no sooner than 20 minutes after your journey has begun. You will then hear an intermittent warning tone twice, and the Attention Assist: Time for a break? message appears in the multifunction display.
If necessary, take a break.
Press to confirm the message.
On long journeys, take regular breaks in good time to allow yourself to rest properly. If you do not take a break and ATTENTION ASSIST still detects typical indicators of fatigue or increasing lapses in concentration, you will be warned again after 15 minutes at the earliest.
ATTENTION ASSIST is reset when you
continue your journey and starts assessing
your tiredness again if:
• you switch off the engine.
• you take off your seat belt and open the
driver's door, e.g. for a change of drivers or
to take a break.
See also:
Selecting a scene/chapter
If the film is divided into scenes or chapters,
you can select them directly while the film is
running, or skip forwards step-by-step. Some
DVDs do not permit this at certain points (e.g.
durin ...
Setting the airflow
► Turn the SmartKey to position 2 in the
ignition lock.
► To increase/reduce: press the
button.
Vehicles with Voice Control System: when the
Voice Control System is switched on, the
...
Exterior mirror out of position
If an exterior mirror has been pushed out of
position, proceed as follows:
► Vehicles without electrically folding
exterior mirrors: move the exterior mirror
into the correct position manu ...