Deleting a destination or the home address from the destination memory
To activate navigation mode: press the function button once or twice.
To show the menu: press the COMAND controller.
Select Destination in the navigation system menu bar by turning the COMAND controller and press to confirm.
Select From Memory and press to confirm.
You will see the destination memory list either with the character bar (option 1) or as a selection list (option 2).
Option 1: destination memory list with character bar: proceed as described in the "Entering characters using the character bar" section.
Option 2: destination memory list as selection list: select a destination by turning the COMAND controller and press to confirm.
You see the address data of the selected entry.
Select Delete and press to confirm.
A prompt appears asking whether you wish to delete the destination.
Select Yes or No and press to confirm.
If you select Yes, COMAND deletes the destination. You will see a message to this effect.
If you select No, the process is aborted.
If the navigable address data for the destination being deleted is also assigned to an address book entry, COMAND will also delete this data from there. If the corresponding address book entry does not contain any further data, such as telephone numbers, COMAND deletes the entire address book entry.
See also:
Important notes on tire pressure
WARNING
Should the tire pressure drop repeatedly:
- check the tire for foreign bodies.
- check whether the wheel is losing air or the
valve is leaking.
- make sure that only a valve cap approve ...
Glare from the side
– Fold down sun visor 1.
– Pull sun visor 1 out of retainer 3.
– Swing sun visor 1 to the side.
– Slide sun visor 1 forwards and back as required.
– Fold down additional sun visor 2. ...
Coolant temperature display
WARNING
Driving when your engine is overheated can
cause some fluids which may have leaked into
the engine compartment to catch fire. You
could be seriously burned.
Steam from an overheated e ...