Avoiding a section of the route blocked by a traffic jam
This function blocks a section of the route ahead of you. You can set the length of the blocked route section. If possible, COMAND calculates a detour around the blocked section of the route.
To activate navigation mode: press the
function button once or twice.
To show the menu: press 
the COMAND
controller.
Select Route in the navigation system
menu bar by turning 
the COMAND
controller and press to confirm.
Select Detour and press to
confirm.
To block a section of the route: select
More or Less repeatedly and confirm using
until the desired section has been
selected.
The total length of the section that can be
blocked is defined by the digital map. The
menu items are available accordingly.
To start route calculation: select Start
and press to confirm.
To delete the blocked section: select
Delete while the message is shown and
press to confirm.
COMAND calculates the route without the block.
See also:
Servicing the brakes
If the red brake warning lamp lights up in the instrument cluster and you hear
a warning tone while the engine is running, the brake fluid level may be too low.
Observe additional warning messag ...
Securing the vehicle to prevent it from
rolling away
WARNING
Only jack up the vehicle on level ground or on
slight inclines/declines. The vehicle could
otherwise fall off the jack and injure you or
others.
If your vehicle is equipped with a wh ...
Checking the coolant level
Only check the coolant level when the vehicle
is on a level surface and the engine has cooled
down.
Turn the SmartKey to position
2 in the ignition lock.
On vehicles with KEYLESS-GO, press ...