Entering a point of interest in the vicinity of the destination

Entering a point of interest in the vicinity of the destination is only possible when route guidance is active.

and press  to confirm. Select Destination Area from the menu and press Continue with assigning the point of to confirm.

interest category. Continue with assigning the point of interest category.

    See also:

    Multicontour seat
    Information about the components and operating principles of COMAND can be found on. The contour of the driver's seat and frontpassenger seat backrests can be individually adjusted to provid ...

    Towing the vehicle with the rear axle raised
    Only possible on vehicles without 4MATIC. When towing your vehicle with the rear axle raised, it is important that you observe the safety instructions. The ignition must be switched off if ...

    Important safety notes
    WARNING When operating the climate control, the air that enters the passenger compartment through the air vents can be very hot or very cold (depending on the set temperature). This could ca ...