Entering an intermediate stop
Introduction
When route guidance is active, you can enter an intermediate stop. Intermediate stops can be predefined destinations from the following categories that COMAND offers for selection:
• Mercedes-Benz Service Center
• Hospital
• Gas Station
• Parking Lot
• Restaurant
However, you can also enter destinations other than the predefined ones. To do this select the menu item Other.
You can use the intermediate stop function to influence route guidance to the main destination. When you have reached your intermediate stop, COMAND automatically recalculates the route to the main destination.
Entering predefined destinations
To activate navigation mode: press the function button once or twice.
To show the menu: press the COMAND controller.
Select Destination in the navigation system menu bar by turning the COMAND controller and pressing to confirm.
Select Stopover and press to confirm.
Option 1: no intermediate stop has been entered yet.
Select a category; see option 2.
Option 2: an intermediate stop has already been entered.
Select Change Stopover and press to confirm.
To select a category: select a category by turning the COMAND controller and pressing to confirm.
COMAND first searches in the selected category for destinations along the route.
If there are no destinations available there, COMAND searches for destinations within a radius of up to 100 km of the vehicle position.
If COMAND finds destinations, a list appears on the right-hand side of the display. The currently selected point of interest is highlighted on the left-hand side of the map.
The intermediate stops are listed according to increasing distance from the current vehicle position. They are displayed in the form of a name and their position in relation to the route and your direction of travel.
If COMAND does not find any destinations, you will see a message to this effect.
Confirm OK by pressing .
Select a different category.
Select the intermediate stop by turning the COMAND controller and pressing to confirm.
To start route calculation: select Start and press to confirm.
Entering another destination as an intermediate stop
To activate navigation mode: press the function button once or twice.
To show the menu: press the COMAND controller.
Select Destination in the navigation system menu bar by turning the COMAND controller and pressing to confirm.
Select Stopover and press to confirm.
Select Other and press to confirm.
Select Address Entry, From Memory, From Last Destinations or From POIs.
Selection | Step |
Address Entry | Enter a destination by address |
From Memory | Select a destination from the destination memory |
From Last Destinations | Select a destination from the list of last destinations |
From POIs | Enter a point of interest |
To start route calculation: once you have entered a destination, select Start and press to confirm.
Deleting an intermediate stop
If an intermediate stop has already been entered, you can delete it.
To activate navigation mode: press the function button once or twice.
To show the menu: press the COMAND controller.
Select Destination in the navigation system menu bar by turning the COMAND controller and pressing to confirm.
Select Stopover and press to confirm.
Select Delete Stopover and press to confirm.
COMAND deletes the intermediate stop and recalculates the route to the main destination.
See also:
Setting the airflow
Turn the SmartKey to position
2 in the
ignition lock.
To increase/reduce: press
the or
button.
You can use automatic climate
control to
set the airflow in the rear compartment
sep ...
Important safety notes
WARNING
Air bags are designed to reduce the incidence
of injuries and fatalities in certain situations:
• frontal impacts (driver's and frontpassenger front air bags)
• side impacts (side i ...
Important safety notes
WARNING
When operating the climate control, the air
that enters the passenger compartment
through the air vents can be very hot or very
cold (depending on the set temperature). This
c ...