Entering a destination using the map
Calling up the map
To activate navigation mode: press the function button once or twice.
To show the menu: press the COMAND controller.
Select Destination in the navigation system menu bar by turning the COMAND controller and pressing to confirm.
Select Via Map and press to confirm.
You see the map with the crosshair.
1 Current vehicle position
2 Crosshair
3 Details of the crosshair position
4 Map scale selected
Display 3 depends on the settings selected in "Map information in the display". The current street name can be shown, provided the digital map contains the necessary data, or the coordinates of the crosshair if the geo-coordinate display is switched on and the GPS signal is strong enough.
Moving the map and selecting the destination
To scroll the map: slide , or the COMAND controller.
To set the map scale: as soon as you turn the COMAND controller, the scale bar appears.
Turn until the desired scale is set.
Turning clockwise zooms out from the map; turning counter-clockwise zooms in.
To select a destination: press the COMAND controller once or several times.
You will see either the address entry menu with the destination address or, if COMAND is unable to assign a unique address, a selection list.
Select a destination by turning the COMAND controller and press to confirm.
If the destination is within the limits of the digital map, COMAND attempts to assign the destination to the map.
If the destination can be assigned, you will see the address entry menu with the address of the destination. If not, you will see the entry Destination from Map.
To start route calculation: select Start and press to confirm.
See also:
Entering characters in the address and the phone book
Introduction
The following section describes how to enter
characters in the phone book/address book
when creating a new entry.
Creating a new entry in the phone book
Call up the input menu wit ...
Engine oil
Vehicles with a diesel particle filter:
If the vehicle is mostly driven for short
distances, it is possible that malfunctions
may occur during the automatic cleaning of
the diesel particle ...
Locking the vehicle
If the vehicle can no longer be locked with the
SmartKey, you can lock it by taking the
following steps.
► Close the front-passenger door, the
rear
door on the front-passenger side and the ...