Automatic car wash
WARNING
Braking efficiency is reduced after washing
the vehicle. This could cause an accident. For
this reason, you must drive particularly
carefully after washing the vehicle until the
brakes have dried.
WARNING
The vehicle is braked when the HOLD function
or DISTRONIC PLUS is activated. Therefore,
deactivate the HOLD function and DISTRONIC
PLUS before the vehicle is washed in an
automatic car wash.
You can wash the vehicle in an automatic car wash from the very start.
Never clean your vehicle in a Touchless Automatic Car Wash as these use special cleaning agents. These cleaning agents can damage the paintwork or plastic parts.
If the vehicle is very dirty, pre-wash it before cleaning it in an automatic car wash.
In car washes with a towing mechanism, make sure that the automatic transmission is in transmission position N, otherwise the vehicle could be damaged.
- Vehicles with a SmartKey:
Do not remove the SmartKey from the ignition lock. Do not open the driver's door or front-passenger door when the engine is switched off. Otherwise, the automatic transmission selects park position P automatically and locks the wheels. You can prevent this by shifting the automatic transmission to N beforehand.
- Vehicles with KEYLESS-GO:
Do not open the driver's door or frontpassenger door when the engine is switched off. Otherwise, the automatic transmission selects park position P automatically and locks the wheels.
Observe the following to make sure that the automatic transmission stays in position N:
•► Make sure the vehicle is stationary and the ignition is switched off.
•► Turn the SmartKey to position 2 in the ignition lock.
Use the SmartKey instead of the Start/ Stop button on vehicles with KEYLESS-GO.
•► Depress and hold the brake pedal.
•► Shift the automatic transmission to position N.
•► Release the brake pedal.
•► Release the parking brake.
•► Switch off the ignition and leave the SmartKey in the ignition lock.
Make sure that:
- the side windows and the sliding sunroof
are fully closed.
- the ventilation/heating is switched off
(the OFF button has been pressed).
- the windshield wiper switch is in position 0.
Otherwise, the vehicle might be damaged.
After using an automatic car wash, wipe off wax from the windshield and the wiper blades. This will prevent smears and reduce wiping noises caused by residue on the windshield.
See also:
Important safety notes
Important safety notes
Do not leave the SmartKey in the cargo
compartment. You could otherwise lock
yourself out
WARNING
When leaving the vehicle, always remove the
SmartKey from the ...
Replacing the windshield wiper blades
Removing the wiper blades
Before changing the wiper blades, always set the wiper arms to a vertical position
using the combination switch. There is otherwise a risk of damaging the hood.
Moving ...
Important information
WARNING
When the climate control system is
deactivated, the outside air supply and
circulation are also deactivated. Only choose
this setting for a short time. Otherwise the
windows could f ...