Opening/closing the garage door
Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.
•► Turn the SmartKey to position 2 in the ignition lock.
•► Press transmitter button 2, 3 or 4 in the overhead control panel that you have programmed to operate the garage door.
Garage door system with a fixed code:
indicator lamp 1 lights up green.
Garage door system with a rolling code:
indicator lamp 1 flashes green.
The transmitter will transmit a signal for as long as the transmitter button is being pressed. After a maximum of ten seconds, transmission is terminated and indicator lamp 1 flashes yellow. Press the transmitter button again, if necessary.
See also:
Important safety notes
The fuses in your vehicle serve to close down faulty circuits.
If a fuse blows, all the components on the circuit and their functions stop operating.
WARNING
Only use fuses approved by Merced ...
Driving with summer tires
Observe the notes in the "Winter operation" section (). ...
Driving on wet roads
Hydroplaning
If water has accumulated to a certain depth
on the road surface, there is a danger of
hydroplaning occurring, even if:
• you drive at low speeds.
• the tires have adequate tread de ...