Activating/deactivating the residual heat function
The residual heat function is only available in vehicles for Canada with automatic climate control.
It is possible to make use of the residual heat of the engine to continue heating the stationary vehicle for up to 30 minutes after the engine has been switched off. The heating time depends on the temperature that has been set.
The blower will run at a low speed regardless of the airflow setting.
If you activate the residual heat function at high temperatures, only the ventilation will be activated. The blower runs at medium speed.
It is possible that the residual heat function may be activated automatically an hour after the SmartKey is removed. The vehicle is then ventilated for 30 minutes to dry the air-conditioning system.
•► Turn the SmartKey to position 0 in the ignition lock or remove it.
•► To activate: press the button.
The indicator lamp above the button lights up.
•► To switch off: press the button.
The indicator lamp above the button goes out.
Residual heat is deactivated automatically:
- after about 30 minutes
- when the ignition is switched on
- if the battery voltage drops
- if the coolant temperature is too low
See also:
Problems with the SmartKey
Problem
Possible causes/consequences and
Solutions
You cannot lock or unlock the vehicle using
the SmartKey.
The SmartKey battery is discharged or nearly discharged.
...
Tires
Problem
Possible causes/consequences and
Solutions
USA
only:
The yellow tire pressure
monitor warning lamp
(pressure loss/
malfunction) is lit.
Canada onl ...
Maximum loaded vehicle weight
The maximum weight is the sum of the curb
weight of the vehicle, the weight of the
accessories, the total load limit and the
weight of the optional equipment installed at
the factory. ...