Adaptive Highbeam Assist
You can use this function to set the headlamps to change between low beam and high beam automatically. The system recognizes vehicles with their lights on, either approaching from the opposite direction or traveling in front of your vehicle, and consequently switches the headlamps from high beam to low beam.
The system automatically adapts the lowbeam headlamp range depending on the distance to the other vehicle. Once the system no longer detects any other vehicles, it reactivates the high-beam headlamps.
The system's optical sensor is located behind the windshield near the overhead control panel.
•► To activate: activate the Adaptive Highbeam Assist function using the onboard computer.
•► Turn the light switch to or .
•► Press the combination switch beyond the pressure point in the direction of arrow 1.
If it is dark and the light sensor activates the low-beam headlamps, the indicator lamp in the instrument cluster lights up.
If you drive faster than approximately 28 mph (45 km/h):
the headlamp range is set automatically depending on the distance between the vehicle and other road users.
If you drive faster than approximately 35 mph (55 km/h) and no other road users are identified:
the high-beam headlamps are switched on automatically. The indicator lamp in the instrument cluster also lights up.
When you drive slower than approximately 30 mph (45 km/h) or if other road users are identified or if the roads are sufficiently illuminated:
the high-beam headlamps are switched off automatically. The indicator lamp in the instrument cluster goes out. The indicator lamp in the instrument cluster stays on.
•► To deactivate: move the combination switch back to its normal position.
The indicator lamp in the instrument cluster goes out.
WARNING
The Adaptive Highbeam Assist is only an aid
intended to support you while driving. The
driver is and remains responsible for proper
vehicle lighting in accordance with the
prevailing light, sight and traffic conditions.
The system may be impaired or unavailable when
- visibility is poor, e.g. due to snow, rain, fog,
or heavy spray
- the optical sensor area of the windshield is
dirty, fogged up, or covered by a sticker for
example
The system cannot recognize the following road users:
- Road users without a lighting system of
their own, e.g. pedestrians
- Road users with dim lighting of their own,
e.g. cyclists
- Road users whose lighting is obstructed,
e.g. road users behind a guardrail
- In some seldom cases, even road users with
a lighting system of their own may be
recognized too late or not at all.
The automatic high-beam headlamps will then not be deactivated or it will be activated in spite of preceding or oncoming road users.
This could endanger you and/or others and cause an accident. Always pay close attention to the traffic situation and switch off the high beam manually if necessary.
See also:
Fuse box in the engine compartment
•► Make sure that the windshield wipers are
turned off.
WARNING
Make sure that the windshield wipers are
switched off and that the SmartKey is
removed from the ignition lock before y ...
Installing the ball coupling
WARNING
If the vehicle/trailer combination is not secured, the trailer may come loose.
As a result, you could cause an accident.
Observe the ball coupling manufacturer's installation inst ...
Air distribution settings
The air distribution can be set individually for
the driver's and front-passenger sides.
Directs air through the
defroster vents
Directs air through the center and
side air vents
Direc ...