Charging the battery
WARNING
Never charge a battery still installed in the
vehicle unless a battery charger unit approved
by Mercedes-Benz is being used. Gases may
escape during charging and cause explosions
that may result in paint damage, corrosion or
personal injury.
A battery charger unit specially adapted for
Mercedes-Benz vehicles and tested and
approved by Mercedes-Benz is available as an
accessory. It permits the charging of the
battery in its installed position. Contact an
authorized Mercedes-Benz Center for further
information and availability.
Charge the battery in accordance with the
separate instructions for the battery charger.
WARNING
There is a risk of acid burns during the
charging process due to the gases which
escape from the battery. Do not lean over the
battery during the charging process.
WARNING
Battery acid is caustic. Avoid contact with the
skin, eyes or clothing.
Only charge the installed battery with a battery charger which has been tested and approved by Mercedes-Benz. These battery chargers allow the battery to be charged while still installed.
Only use battery chargers with a maximum charging voltage of 14.8 V.
Only charge the battery using the jumpstarting connection point.
The jump-starting connection point is in the engine compartment.
Open the hood.
Connect the battery charger to the positive
terminal and earth point in the same order
as when connecting the donor battery in
the jump-starting procedure.
Read the battery charger's operating
instructions before charging the battery.
See also:
Cleaning the seat belts
– Use clean, lukewarm water and soap
solution.
Do not clean the seat belts using chemical
cleaning agents. Do not dry the seat belts
by warming them above 176 °F (80 °C) or
placing them ...
2008 Mercedes-Benz GL-Class Review
Last year, Mercedes-Benz introduced the seven-seat GL-Class, an SUV that will
inevitably find its way into the sort of neighborhoods where one Banana Republic
just isn't enough. For 2008, Mercedes ...
DOT, Tire Identification Number (TIN)
U.S. tire regulations prescribe that every
manufacturer of new tires or retreader has to
imprint a TIN in or on the sidewall of each tire
produced.
The TIN is a unique identification number. ...