Opening/closing the garage door
Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.
Turn the SmartKey to position 2
in the
ignition lock.
Press transmitter button 2, 3 or 4
in the
overhead control panel that you have
programmed to operate the garage door.
Garage door system with a fixed code: indicator lamp 1 lights up green.
Garage door system with a rolling code: indicator lamp 1 flashes green.
The transmitter will transmit a
signal for
as long as the transmitter button is being
pressed. After a maximum of ten seconds,
transmission is terminated and indicator
lamp 1 flashes yellow. Press the
transmitter button again, if necessary.
See also:
Fogged up or dirty windshield
If the windshield in front of the camera is
fogged up or dirty on the inside or outside, the
Night View Assist Plus display is affected.
WARNING
Please do not forget that your primary
respons ...
Storing settings
With the memory function, you can store up to three different settings, e.g.
for three different people.
The following settings are stored as a single memory preset:
position of the seat, backr ...
2008 Mercedes-Benz M-Class Review
Until a 2008 M-Class was assigned to me for this review, I had kind of
forgotten that Mercedes redesigned this luxury SUV two years ago. Sure, I knew
about the update when it was first announced, ...
