System self-test
After you have switched on the ignition, the system carries out a self-diagnosis.
WARNING
A malfunction in the system has been
detected if one of the following conditions
occurs:
• the indicator lamp in the SOS button does not light up during the system
self-diagnosis.
• the indicator lamp in the
Roadside Assistance button does not light up during the system self-diagnosis.
• The indicator lamp in the
information button does not light up during selfdiagnosis of the system.
• the indicator lamp in the SOS button,
Roadside Assistance button or
information button continues to be
lit red after the system self-diagnosis.
• The Tele Aid Inoperative or Tele Aid Not Activated message appears in the
multifunction display after the system self-test.
If a malfunction is indicated as outlined above,
the system may not operate as expected. In
the event of an emergency, assistance must
be summoned by other means.
Have the system checked at the nearest
authorized Mercedes-Benz Center or contact
the following service hotlines:
• USA: Mercedes-Benz Customer Assistance
Center under
1-800-FOR-MERCedes(1-800-367-6372)
or 1-888-990-9007
• Canada: Customer Service at
1-888-923-8367
See also:
Mercedes-Benz G-Class: a success story that spans three decades
The classic Mercedes-Benz Cross-Country Vehicle serves up a majestic blend of
high-performance powertrain and dynamic handling control systems. In addition to
permanent all-wheel drive with a low- ...
Blind Spot Assist
Important safety notes
Blind Spot Assist uses a radar sensor system
to monitor the areas on both sides of your
vehicle. It supports you from speeds of
approximately 20 mph (30 km/h). A warning ...
Adjusting the four-way lumbar
support
You can adjust the contour of the front seat
backrests individually to provide optimum
support for your back.
1 To raise the backrest contour
2 To soften the backrest contour
3 To lower the ...
