Activating the rear view camera
Make sure that the SmartKey is
in position 2 in the ignition lock.
Make sure that the "rear view
camera" function is selected in COMAND (see the separate operating instructions
for COMAND).
Engage reverse gear.
The area behind the vehicle is shown in the COMAND display.
See also:
Belt warning for the driver and frontpassenger
Regardless of whether the driver and front
passenger have fastened their seat belts
already, the seat belt warning lamp
lights up for 6 seconds after every engine
start. It then goes out if the d ...
Tire pressure monitor warning
messages
If the tire pressure monitor detects a
significant pressure loss on one or more tires,
a warning message is shown in the
multifunction display. A warning tone also
sounds and the tire pressure ...
"Coupling up a trailer" function
This function is only available on vehicles with
a trailer tow hitch.
1 Center of the vehicle on the red guide line
approximately 10 in (0.25 m) away from
the rear area
2 Center of the vehic ...