Activating the HOLD function
Make sure that the activation
conditions
are met.
Depress the brake pedal.
Quickly depress the brake pedal
further
until HOLD display 1 appears in the
multifunction display.
The HOLD function is activated. You can
release the brake pedal.
If depressing the brake pedal
the first
time does not activate the HOLD function,
wait briefly and then try again.
WARNING
The vehicle's brakes are applied when the
HOLD function is activated. For this reason,
deactivate the HOLD function if the vehicle is
to be set in motion by other means (e.g. in a
car wash or by towing).
See also:
Tachometer
The red band in the tachometer indicates the
engine's overrevving range.
Do not drive in the overrevving range, as
this could damage the engine.
The fuel supply is interrupted to protect the ...
Cleaning the paintwork
Scratches, corrosive deposits, areas affected
by corrosion and damage caused by
inadequate care cannot always be completely
repaired. In such cases, visit a qualified
specialist workshop, e.g. ...
Activating the rear view camera
Make sure that the SmartKey is
in position 2 in the ignition lock.
Make sure that the "rear view
camera" function is selected in COMAND (see the separate operating instructions
for ...