Activating/deactivating the residual heat function

The residual heat function is only available in vehicles for Canada with automatic climate control.

It is possible to make use of the residual heat of the engine to continue heating the stationary vehicle for up to 30 minutes after the engine has been switched off. The heating time depends on the temperature that has been set.

speed The blower will run at a low speed regardless of the airflow setting.

heat function If you activate the residual heat function at high temperatures, only the ventilation will be activated. The blower runs at medium speed.

0 in the ignition lock or remove it. Turn the SmartKey to position 0 in the ignition lock or remove it.
button. To activate: press the The indicator lamp in the  button button.
The indicator lamp in the lights up. button lights up.
button. To switch off: press the The indicator lamp in the  button button.
The indicator lamp in the goes out. button goes out.

automatically: Residual heat is deactivated automatically:
• after about 30 minutes
• when the ignition is switched on
• if the battery voltage drops
• if the coolant temperature is too low

    See also:

    Change of direction
    Introduction Changes of direction have three phases: • preparation phase • announcement phase • change-of-direction phase Preparation phase COMAND prepares you for the upcoming change of ...

    Safety guidelines for seat belts, Emergency Tensioning Devices (ETDs) and air bags
    WARNING - Damaged seat belts or seat belts that have been subjected to stress in an accident must be replaced. Their anchoring points must also be checked. Only use seat belts installed or s ...

    Not Crossing Over
    From Honda to BMW, the handbook on wagon styling evidently calls for anything but a wagon — which leads to sleek, quasi-crossover profiles that lead to minimal cargo room and even worse blind spot ...