Tail lamp

Open the trunk. Switch off the lights.
Open the side trim panel. Open the trunk.
Open the side trim panel.

Remove the tail lamp connector

Simultaneously press retaining lugs Remove the tail lamp connector
1 in the direction of the arrow and slightly pull out the bulb holder with the Simultaneously press retaining lugs 1 in the direction of the arrow and slightly pull out the bulb holder with the bulbs.
functions from the top of the bulb holder. Remove the connector for LED light functions from the top of the bulb holder.
bulbs. Pull the bulb holder out with the bulbs.

1 Backup lamp

1 Backup lamp
2 Brake lamp
3 Parking lamp/brake lamp

or 3 back and turn it counter-clockwise to remove it from the bulb holder. Press the respective bulb 1, 2 or 3 back and turn it counter-clockwise to remove it from the bulb holder.
holder and turn it clockwise. Insert the new bulb into the bulb holder and turn it clockwise.
light functions in the bulb holder. Reinsert the connector for LED light functions in the bulb holder.
lock it in place. Insert the bulb holder again and lock it in place.
Close the side trim panel Insert the tail lamp connector.
Windshield wipers Close the side trim panel

    See also:

    Fuel grade
    You should only refuel with unleaded premium-grade gasoline as this avoids damaging the catalytic converter. If engine running problems are apparent, have the cause checked immediately and rep ...

    Checking the coolant level
    Only check the coolant level when the vehicle is on a level surface and the engine has cooled down. Turn the SmartKey to position 2 in the ignition lock. On vehicles with KEYLESS-GO, press ...

    Activating with the current or last stored speed
    WARNING The set speed stored in memory should only be set again if prevailing road conditions and legal speed limits permit. Possible acceleration or deceleration differences arising from re ...