Calling up a stored setting

from the fully If you want to move the seat from the fully reclined position to a stored seat position, first raise the backrest. The seat could otherwise be damaged.

storage Press and hold the relevant storage position button 1, 2 or 3 until the seat, steering wheel and exterior mirrors are in the stored position.

interrupted as The setting procedure is interrupted as soon as you release the storage position button.

    See also:

    Problems with PARKTRONIC
    Problem Possible causes/consequences and Solutions Only the red segments in the PARKTRONIC warning displays are lit. You also hear a warning tone for approximately two s ...

    Blind Spot Assist
    Important safety notes Blind Spot Assist uses a radar sensor system to monitor the areas on both sides of your vehicle. It supports you from speeds of approximately 20 mph (30 km/h). A warning ...

    Using the rear center seat belt
    If the left-hand rear seat backrest is folded down and back up again, the rear center seat belt may lock. The seat belt can then not be pulled out. To release the rear center seat belt: pull out ...