Problems with the sliding sunroof

Your vehicle may be equipped with a sliding sunroof or a panorama roof with power tilt/sliding panel. In the following section, the term "sliding sunroof" refers to both types of sliding sunroof.

Problem: the sunroof cannot be closed and you cannot see the cause.

WARNING
You could be severely or even fatally injured when closing the sliding sunroof with increased closing force or if the antientrapment feature is deactivated. Make sure that nobody can become trapped when closing the sliding sunroof.

If the sliding sunroof is obstructed during closing and reopens again slightly:
sunroof Immediately after the sliding sunroof blocks, pull the overhead control panel down to the point switch in the overhead control panel down to the point of resistance and hold it until the sliding sunroof is closed.
The sliding sunroof is closed with increased force.

If the sliding sunroof is obstructed again during closing and reopens again slightly:
sunroof Immediately after the sliding sunroof blocks, pull the overhead control panel down to the point switch in the overhead control panel down to the point of resistance and hold it until the sliding sunroof is closed.
The sliding sunroof is closed without the anti-entrapment feature.

WARNING
Pressing and holding the sliding sunroof switch to close the sliding sunroof immediately after it had been blocked two times will cause the sliding sunroof to close without the anti-entrapment feature for as long as you hold the switch.

cannot be If the sliding sunroof still cannot be opened or closed as a result of a malfunction, contact a qualified specialist workshop.

    See also:

    Adjusting the head restraints electrically
    - To adjust the head restraint height: slide the switch for head restraint adjustment up or down in the direction of the arrow. ...

    Vehicle
    Display messages Possible causes/consequences and Solutions You have attempted to start the engine with the transmission in position R or D. – Shift the transmiss ...

    Deactivating the HOLD function
    The HOLD function is deactivated automatically if:  - you accelerate and the transmission is in position D or R.  - you shift the transmission to position P.  - you apply t ...