Opening and closing

Overhead control panel
Overhead control panel

1 To open
2 To open
3 To close

1 or 2 in the ignition lock. Turn the SmartKey to position 1 or 2 in the ignition lock.

switch in the corresponding Press or pull the direction. switch in the corresponding direction.

switch beyond the If you press the point of resistance, an automatic opening/closing process is started in the switch beyond the point of resistance, an automatic opening/closing process is started in the corresponding direction. You can stop automatic operation by operating the switch again.

    See also:

    Notes on care
    Regular care of your vehicle is a condition for retaining the quality in the long term. Use care products and cleaning agents recommended and approved by Mercedes- Benz. WARNING   Many ...

    Restoring the factory settings
    ► Press the buttons simultaneously for approximately six seconds until the battery check lamp flashes twice. ...

    Example: step 1 to 3
    The following table shows examples on how to calculate total and cargo load capacities with varying seating configurations and number and size of occupants. The following examples use a load l ...