ATA (Anti-Theft Alarm system)

A visual and audible alarm is triggered if the alarm system is armed and you open:
• a door
• the vehicle with the mechanical key
• the trunk lid
• the hood

The alarm is not switched off, even if you close the open door that has triggered it, for example.

than 30 If the alarm stays on for more than 30 seconds, the emergency call system mbrace (USA only) or TELE AID (Canada only) initiates a call to the Customer Assistance Center automatically. The emergency call system initiates the call provided that:
• you have subscribed to the mbrace/TELE AID service.

• the mbrace/TELE AID service has been activated properly.

• the required mobile phone, power supply and GPS are available.

To arm: lock the vehicle

with the SmartKey or KEYLESS-GO. To arm: lock the vehicle with the SmartKey or KEYLESS-GO.
Indicator lamp 1 flashes. The alarm system is armed after approximately 15 seconds.
vehicle with the SmartKey or KEYLESS-GO. To deactivate: unlock the vehicle with the SmartKey or KEYLESS-GO.
SmartKey: To stop the alarm using the SmartKey:
insert the SmartKey into the ignition lock. The alarm is switched off.

or

or Press the button on the SmartKey. or The alarm is switched off. button on the SmartKey.
The alarm is switched off.
KEYLESS-GO: To stop the alarm using KEYLESS-GO:
grasp the outside door handle. The SmartKey must be outside the vehicle.
The alarm is switched off.

or

the dashboard. The SmartKey must be inside the vehicle. Press the Start/Stop button on the dashboard. The SmartKey must be inside the vehicle.
The alarm is switched off.

    See also:

    Cup holder in the rear seat armrest
    Do not sit on or support your body weight on the rear seat armrest when it is folded down, as you could otherwise damage it. Close the cup holder before folding the rear seat armrest up. ...

    Treadwear indicators
    Narrow bars (tread wear bars) that are distributed over the tire tread. If the tire tread is level with the bars, the wear limit of 1/16 in (1.6 mm) has been reached. ...

    Storing a phone number which has not yet been stored
    Introduction For incoming calls from a person who is not in the address book, COMAND displays the phone number in the call list. You can save this entry. Storing as a new entry in the address ...