Opening and closing
Overhead control panel
1 To raise
2 To open
3 To close/lower
The panorama roof with power tilt/sliding
panel can only be operated when the roller
sunblind is open.
- Turn the SmartKey to position 1 or 2 in the
ignition lock.
- Push or pull the
switch in the
corresponding direction.
If you press the
switch beyond the
point of resistance, an automatic opening/closing process is started in the
corresponding direction. You can stop
automatic operation by operating the
switch again.
When raising the roof, automatic operation
is only available if the sliding sunroof is in
the closed position.
See also:
Inserting and removing DVDs
Proceed as described in the "Inserting and
ejecting CDs and DVDs" section. ...
Information about driving abroad
Converting to symmetrical low beam
when driving abroad: switch the headlamps
to symmetrical low beam in countries in
which traffic drives on the opposite side of the
road to the country where ...
SRS warning lamp
SRS functions are checked regularly when
you switch on the ignition and when the
engine is running. Therefore, malfunctions
can be detected in good time.
The SRS warning lamp in the
instrume ...