SRS warning lamp

SRS functions are checked regularly when you switch on the ignition and when the engine is running. Therefore, malfunctions can be detected in good time.

The instrument SRS warning lamp in the instrument cluster lights up when the ignition is switched on. It goes out no later than a few seconds after the engine is started.

The SRS components are in operational readiness when the is not lit while the engine is running. SRS warning lamp is not lit while the engine is running.

WARNING
The SRS self-check has detected a malfunction if the
warning lamp: SRS warning lamp:
• does not come on at all
• fails to go out approximately 4 seconds after the engine was started
• comes on after the engine was started or while driving
For your safety, Mercedes-Benz strongly recommends that you have the system checked as soon as possible at an authorized Mercedes-Benz Center. Otherwise the SRS may not be activated when it is needed in an accident, which could result in serious or fatal injury. The SRS might also deploy unexpectedly and unnecessarily which could also result in injury.
In addition, improper work on the SRS creates a risk of rendering the SRS inoperative or causing unintended air bag deployment. Work on the SRS must therefore only be performed by qualified technicians. Contact an authorized Mercedes-Benz Center.
If it is necessary to modify an air bag system to accommodate a person with disabilities, contact an authorized Mercedes-Benz Center for details. USA only: Call our Customer Assistance Center at 1-800-FOR-MERCedes (1-800-367-6372) for details.

    See also:

    Selecting a folder
    This function is only available in MP3 mode. Switch on MP3 mode. Select Search by sliding and turning the COMAND controller and press to confirm. Select Folder by sliding and turning ...

    Extending and retracting the cargo compartment cover
    To extend: pull cargo compartment cover 1 back and clip it into the retainers on the left and right. To retract: unhook cargo compartment cover 1 from the retainers on the left and right ...

    Activating the HOLD function
    Make sure that the activation conditions are met. Depress the brake pedal. Quickly depress the brake pedal further until HOLD display 1 appears in the multifunction display. The HOLD ...