Switching on DISTRONIC, storing andmaintaining the current speed
WARNING
The vehicle can be braked when DISTRONIC
is activated. For this reason, deactivate
DISTRONIC if the vehicle is to be set in motion
by other means (e.g. in a car wash or by
towing).
You can activate DISTRONIC in the following circumstances:
• if the engine has been started and you
have
been driving for up to two minutes
• while driving, except if you brake
• if the parking brake is not applied
• if ESP® is activated
• if the transmission is in position D
Activating while driving
When driving at speeds below 20 mph (30 km/h), you can only activate DISTRONIC PLUS if the vehicle in front has been detected and is shown in the multifunction display. If the vehicle in front is not shown in the multifunction display and is no longer being detected, because it has changed lanes, for example, DISTRONIC is deactivated and you hear a warning tone.
► Briefly pull the cruise control lever towards you 4 or press it up 1 or down 2 to the pressure point.
DISTRONIC is activated.
► Keep the cruise control lever pressed up 1 or down 2 until the desired speed is set.
► Remove your foot from the accelerator pedal.
Your vehicle adapts its speed to that of the vehicle in front, but only up to the desired stored speed.
You can use the cruise control lever to set
the stored speed and the thumbwheel on
the cruise control lever to set the specified
minimum distance.
If you do not fully release the accelerator
pedal, the DISTRONIC Override message
appears in the multifunction display. The
set distance to a slower-moving vehicle in
front will then not be maintained. You will
be driving at the speed you determine by
the position of the accelerator pedal.
Driving
If there is no vehicle in front, DISTRONIC operates in the same way as cruise control.
If a slower-moving vehicle is detected in front, DISTRONIC causes your vehicle to brake and maintain the preset distance to the vehicle in front.
If DISTRONIC detects a faster-moving vehicle in front, it increases the driving speed, but only up to the desired speed you have stored.
WARNING
If you depress the brake pedal, DISTRONIC is
deactivated. DISTRONIC will then no longer
brake your vehicle. In such cases, control the
distance from vehicles traveling in front with
the brake alone. You could otherwise cause
an accident and thereby injure yourself and
others. The driver remains fully responsible for the vehicle's distance from
other vehicles,
the speed being driven and for braking in good
time.
Stopping
WARNING
DISTRONIC must never be operated,
activated or deactivated by a passenger or
from outside the vehicle.
If DISTRONIC detects that the vehicle in front is stopping, it brakes your vehicle until it is stationary.
Depending on the specified minimum
distance, your vehicle will come to a
standstill at a sufficient distance behind the
vehicle in front. The specified minimum
distance is set using the thumbwheel on
the cruise-control lever.
DISTRONIC is deactivated automatically when stopping:
• on flat stretches of road or on downhill
gradients when the vehicle is stationary
• while the vehicle is still moving on uphill
gradients, to prevent the vehicle from
unexpectedly rolling back when
DISTRONIC is deactivated
If DISTRONIC is deactivated, you will hear a warning tone.
► To prevent the vehicle from rolling away, apply the foot brake or parking brake.
See also:
Selecting the display language
Select System using the
buttons on the remote control and press
the button to confirm.
You see the system menu on the selected
rear screen.
Select Settings using the
button
and conf ...
Warning displays
The warning displays show the distance
between the sensors and the obstacle. The
warning display for the front area is located
on the dashboard above the center air vents.
The warning display f ...
DISTRONIC PLUS displays in the speedometer
When DISTRONIC PLUS is activated, one or
two segments 2 in the set speed range light
up.
For design reasons, the speed
displayed
in the speedometer may differ slightly from
the speed set ...