Transfer case

The vehicle has permanent 4-wheel drive (4MATIC). Power is always transmitted to both axles.

out on a 2-axle dynamometer. The brake Performance tests may only be carried out on a 2-axle dynamometer. The brake system or transfer case could otherwise be damaged. Contact a qualified specialist workshop for a performance test.

Mercedes-Benz recommends that you use an authorized Mercedes-Benz Center for this purpose.

brake dynamometer, the ignition must be If the parking brake is being tested on a brake dynamometer, the ignition must be switched off (SmartKey or Start/Stop button in position 0 or 1), as ESP® will otherwise automatically intervene. The test must last a maximum of 10 seconds. The brake system could otherwise be damaged.

    See also:

    Step-by-step instructions
    The following steps have been developed as required of all manufacturers under Title 49, Code of U.S. Federal Regulations, Part 575 pursuant to the "National Traffic and Motor Vehicle Saf ...

    Important safety notes
    WARNING When operating the climate control, the air that enters the passenger compartment through the air vents can be very hot or very cold (depending on the set temperature). This could ca ...

    Storing the current speed or calling upthe last stored speed
    WARNING   The set speed stored in memory should only be set again if prevailing road conditions and legal speed limits permit. Possible acceleration or deceleration differences arising ...