Windshield washer system and headlamp cleaning system
The washer fluid reservoir is used for both the windshield washer system and the headlamp cleaning system.
Vehicle components and their service products must match. You should, therefore, only use products that have been tested and approved by Mercedes-Benz. Information on tested and approved products can be obtained at any authorized Mercedes-Benz Center or on the Internet at http://www.mbusa.com (USA only).
WARNING
Washer solvent/antifreeze is highly flammable. Do not spill washer solvent/ antifreeze on hot engine parts, because it may ignite and burn. You could be seriously burned.
At temperatures below freezing: always fill the washer fluid reservoir with a mix of water and windshield washer concentrate (e.g. MB WinterFit). There is otherwise a risk of damaging the windshield washer system/headlamp cleaning system.
Only use washer fluid concentrate which is suitable for plastic lenses. Unsuitable washer fluid concentrate could damage the plastic lenses of the headlamps.
Do not add distilled or de-ionized water to the washer fluid container. Otherwise, the level sensor may be damaged.
Add windshield washer concentrate, e.g. MB SummerFit, to the washer fluid all year round.
Example: washer fluid reservoir
- Mix the windshield washer fluid in a container beforehand.
- At temperatures above freezing: fill the washer fluid reservoir with a mix of water and windshield washer concentrate (e.g. MB SummerFit).
- At temperatures below freezing: fill the washer fluid reservoir with a mix of water and windshield washer concentrate (e.g. MB WinterFit). Adapt the mixing ratio to the outside temperature. For information on the mixing ratio ().
- To open: pull cap 1 upwards by the tab.
- Add the premixed washer fluid.
- To close: press cap 1 onto the filler neck until it engages.
See also:
Range of the sensors
General notes
The sensors must be free of dirt, ice and
slush; otherwise they may not function
correctly. Clean the sensors regularly, taking
care not to scratch or damage them
Side view, Se ...
Warning and display messages in the
multifunction display
– Activate ATTENTION ASSIST using the onboard
computer (Y page 232).
Symbol 1 appears in the multifunction
display.
– If necessary, take a break.
– Press or
to confirm the
message.
On l ...
Overview
The on-board computer is activated as soon
as you turn the SmartKey to position 1 in the
ignition lock.
You can control the multifunction display and
the settings in the on-board computer using ...