Calibrating the compass
- Make sure that there is sufficient space for you to drive in a circle without impeding the remaining traffic.
In order to calibrate the compass correctly, observe the following points:
- calibrate the compass in the open and not in the vicinity of steel constructions or highvoltage transmission lines.
- switch off electrical consumers, for example, the climate control, windshield wipers or rear window defroster.
- close all doors and the tailgate.
- Switch the ignition on.
- Press a round pin into opening 3() for approximately six seconds until the C symbol appears in compass display 2().
- Drive a full circle at approximately 3 mph (5 km/h) to 6 mph (10 km/h). Once the calibration has been successfully completed, the current direction appears in compass display 2().
See also:
Important safety notes
WARNING
To help avoid personal injury during a collision or sudden maneuver, exercise
care when storing objects in the vehicle. Put luggage or cargo in the cargo compartment
if possible. Do not p ...
Useful information
This Operator's Manual describes all
models and all standard and optional
equipment of your vehicle available at the
time of publication of the Operator's
Manual. Country-specific differences ...
Other bulbs
There are bulbs other than the Xenon bulbs
that you cannot replace. Replace only the
bulbs listed. Have the bulbs that
you cannot replace yourself changed at a
qualified specialist workshop.
...