Opening/closing the garage door

Once programmed, the integrated remote control will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.

X Turn the SmartKey to position 2 in the ignition lock.

X Press transmitter button 2, 3 or 4 in the overhead control panel that you have programmed to operate the garage door. Garage door system with fixed code: indicator lamp 1 lights up continuously.

Garage door system with rolling code: indicator lamp 1 flashes briefly and then lights up for approximately two seconds. This is repeated for up to 20 seconds.

is being pressed. The transmission will be halted after a maximum of 20 seconds The transmitter will transmit a signal for as long as the transmitter button is being pressed. The transmission will be halted after a maximum of 20 seconds and indicator lamp 1 will flash. Press the transmitter button again, if necessary.

    See also:

    Playback options
    The following options are available to you: • Normal Track Sequence The tracks are played in the normal order (e.g. track 1, 2, 3, etc.). In MP3 mode, the track order is determined by the ord ...

    The mbrace system
    The mbrace system provides different services, e.g.: • automatic and manual emergency call • Roadside Assistance call • MB Info call To adjust the volume during an mbrace call, proceed as foll ...

    Checking the coolant level
    Only check the coolant level when the vehicle is on a level surface and the engine has cooled down. ► Turn the SmartKey to position 2 in the ignition lock. On vehicles with KEYLESS-GO, ...