Opening/closing the garage door

Once programmed, the integrated garage door opener will assume the function of the garage door system's remote control. Please also read the operating instructions for the garage door system.

ignition lock. Turn the SmartKey to position 2 in the ignition lock.

overhead control panel that you have Press transmitter button 2, 3 or 4 in the overhead control panel that you have programmed to operate the garage door.

Garage door system with a fixed code:

indicator lamp 1 lights up green.

Garage door system with a rolling code:

indicator lamp 1 flashes green.

as long as the transmitter button is being The transmitter will transmit a signal for as long as the transmitter button is being pressed. After a maximum of ten seconds, transmission is terminated and indicator lamp 1 flashes yellow. Press the transmitter button again, if necessary.

    See also:

    Driver's knee bag
    Driver's knee bag 1 provides additional protection for the driver against: • knee injuries • thigh injuries • lower leg injuries Driver's knee bag 1 deploys below the steering wheel. During a ...

    Vehicle identification plate
    Even if you have calculated the total load carefully, you should still make sure that the gross vehicle weight rating and the gross axle weight rating are not exceeded. Details can be found on ...

    Opening the tailgate from inside thevehicle
    WARNING   Do not leave children unattended in the vehicle. Children could open the tailgate from the inside, which could result in an accident and/or serious personal injury. Always m ...