Copying data to a storage medium
Insert an SD card into the SD card slot
or
Insert a USB stick into the socket on the
side in the glove box.
Select Vehicle in the main function bar by
turning 
the COMAND controller and
press 
to confirm.
The "Vehicle" menu appears.
Select System and press to
confirm.
Select Upload/Download Data and press
to confirm.
Select Copy Data to Storage Medium
and press to confirm.
Select the storage medium to which the
data should be copied.
Select Start Copying.
COMAND checks whether the storage medium has enough storage capacity. If there is enough storage capacity, the data is copied to the storage medium.
If there is not enough storage capacity,
remove the storage medium. Make more
storage space available on the storage
medium. Then, try to copy the COMAND
data to the storage medium again.
Remove the storage medium.
See also:
Setting the time zone and switching between summer and standard time
Select Vehicle in the main function bar by
turning the COMAND controller and
press to confirm.
Select System by turning
the
COMAND controller and press to
confirm.
Select Time b ...
Towing the vehicle with the rear axle raised
Only possible on vehicles without
4MATIC.
When towing your vehicle with the rear axle
raised, it is important that you observe the
safety instructions.
The ignition must be switched
off if ...
General notes
WARNING
COMAND calculates the route to the
destination without taking into account the
following, for example:
• Traffic lights
• Stop and right-of-way signs
• Lane merging
• Parkin ...