Switching the ECO function on/off
The ECO start/stop function switches the engine off automatically if the vehicle is stopped under certain conditions. When pulling away again, the engine starts automatically. You can switch the ECO start/stop function on and off using COMAND.
If you switch the ECO start/stop function off using COMAND, the function is switched on again automatically when you switch the ignition off and on again.
To switch the ECO start/stop function on/off: select Vehicle in the main function bar by sliding and turning the COMAND controller and press to confirm.
The main area is active.
Select the ECO function by sliding or turning the COMAND controller and press to confirm.
The ECO start/stop function is switched on and off alternately.
See also:
Tires
The specified tire pressure is printed in yellow on the
emergency/collapsible spare wheel. ...
introduction
You can establish a Bluetooth® connection to
COMAND (see the separate operating
instructions).
WARNING
A driver's attention to the road must always
be his/her primary focus when driving. F ...
Daytime running lamps
Daytime running lamps in Canada
The daytime running lamps function is
required by law in Canada. It cannot therefore
be deactivated.
•► Turn the light switch to or
.
With the engine run ...