Setting the map to the vehicle position, intermediate stop or destination position
Centering the map on the vehicle position
To show the menu: press 
the COMAND
controller.
Select Position in the navigation system
menu bar by sliding 
and turning 
the COMAND controller and press to
confirm.
Select Vehicle Position Map and press
to confirm or, if the crosshair is
shown,
press the 
back button.
This hides the crosshair.
Centering on an intermediate stop
This function requires that a route to an intermediate stop has been calculated.
To show the menu: press
the COMAND
controller.
Select Position in the navigation system
menu bar by sliding and turning
the COMAND controller and press to
confirm.
Select Stopover Map and press
to
confirm.
The crosshair is centered on the destination.
Centering on the destination
This function requires that a route to a destination has been calculated.
To show the menu: press
the COMAND
controller.
Select Position in the navigation system
menu bar by sliding and turning
the COMAND controller and press to
confirm.
Select Destination Map and press
to
confirm.
The crosshair is centered on the destination.
See also:
Restoring the factory settings
- Press the and
buttons
simultaneously for approximately six
seconds until the battery check lamp
flashes twice. ...
Opening/closing the garage door
Once programmed, the integrated remote control will assume the function of the
garage door system's remote control. Please also read the operating instructions
for the garage door system.
X T ...
Dialing a number from the phone book
If your mobile phone is able to receive calls,
you can search for and dial a number from the
phone book in the audio system or COMAND
at any time.
Press the
or
button on the
steering whe ...